DHS Z-Wave inwall Double Switch controller

DHS

$99.95

This product is currently sold out

The Z-Wave In-Wall Double Switch Controller is a wireless controller which can be a part of many whole-home automation solutions. 

  • Control the ON-OFF function of two independent circuits remotely or using a momentary / bell type switch
  • Compatible with all Z-Wave networks
  • Acts as a repeater expanding your Z-Wave network
  • Wide range of compatibility with existing light fittings and does NOT require expensive cabling

Product Details

The Z-Wave In-Wall Double Switch Controller is an advanced Z-Wave controller perfect for remotely operating your existing light fittings. It works with Z-Wave enabled controllers (AUS/NZ version) and can be controlled individually or as part of a group in a pre-configured Scene.

The Z-Wave In-Wall Double Switch Controller is designed to operate inside your wall socket and can be easily installed by a qualified electrician.

The controller is also compatible with many popular BELL PRESS type light fittings including Clipsal IMPRESS and SATURN wall switches.

Example of wiring with Clipsal Saturn range 2 gang wall plate and two 30/60PBBPL Bell Press buttons. Clipsal Saturn range 2 gang wall plate and two 30/60PBBPL Bell Press buttons are sold seperately.

 

This product integrates with all Australian certified (921.42MHz) Z-Wave controllers including:

  • Vera 3/Lite
  • Raspberry PI with RaZberry Card
  • Fibaro Home Controller 2/Lite
  • REMOTEC Z-Wave Advanced Remote Controller

 

Please Note:

Please check the maximum load before installing or operating.
This installation must be done by a certified electrician in Australia and New Zealand.
Before engaging an electrician, check that they provide an electrical compliance certificate.
For warranty claim you have to provide installation compliance certificate from your electrician.

 

 Product Support

Manuals:

Z-Wave In-Wall Double Switch Manual (Size: 151 KB)

 

 Technical Specifications

 

RF Protocol
Z‐Wave, MultiChannel Command Class
RF Frequency
921.42Mhz ‐ AU/NZ  approved RF for Z‐wave
Z‐wave device type
Z-Wave Binary Switch, Routing Slave
Manual Switch Compatibility
BELL PRESS type only
Power
AC 240V / 50Hz
Operation Range
Up to 20m indoors with no obstacles
Application
Indoor use only
Operation temperature
0 ~ 55 °C
Max Loading
 6A / 1440W each circuit
Storage temperature
‐10 ~ 70 °C
Weight
50g
Housing
ABS
Compliance
AS/NZS 4268:2008, AS/NZS CISPR 14.1, IEC60669-2-1
Regulatory Compliance Mark
N5496
Dimensions
(LxWxH) 48mm x 45mm x 18mm

Share this

Similar Products